C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
completely removed before the new sealing ring is installed.
Lubricate the surface of the seal that the camshaft rotates against. Install the camshaft seal. Use drift 999 5450.
NOTE: The seal is normally pressed in so that it is level with the internal beveled edge. If the shaft journal is showing signs of wear, the seal can be
pressed in 2 mm deeper by turning the drift socket.
Installing Components
Install:
-
the trigger wheel.
-
the camshaft position (CMP) sensor housing and a new cover.
-
the torque rod bracket. Tighten.
-
the cover over the ignition coils.
-
the charge air pipe over the engine. Remove the seals.
-
the air cleaner (ACL) cover and the intake air hose.
-
the engine stabilizer brace. Tighten the screws at the suspension turrets and the screw for the engine bracket.
Check the engine compartment. Wipe the engine compartment clean.
