C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
-
Slacken off the nipple at the steering gear.
-
Pull down the front section of the hose.
-
Remove the hose.
NOTE: Make a note of the routing of the hose.
Installing
-
Install a new hose
-
Thread the nipple into the steering gear (use a new O-ring).
-
Press up the front section of the hose into the engine compartment.
-
Install the clamp and bracket in the front sub-frame
-
Install the clamp and bracket in the rear sub-frame.
-
Lightly tighten all screws.
Tighten:
-
the nipple in the steering gear. Tighten to 25 Nm
-
screw in the bracket. Tighten to 24 Nm
-
screw clips. Tighten to 5 Nm.
Lower the car.
-
Tighten the nipple in the pump. Tighten to 25 Nm.
NOTE: Use a new O-ring
Remove the lock grip pliers.