C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
Lubricate all studs on the turbocharger (TC) using paste, P/N: 11 61 408 .
Lift up the exhaust system and connect it to the rear system.
Then connect to the turbocharger (TC)/manifold.
Hint: Use a mobile jack with universal plate 999 5972 FIXTURE See: Tools and Equipment/999 5972 Fixture as support.
Install
-
new nuts at the turbocharger/manifold connection.
Tighten to 25 Nm .
Note! Ensure that the flange on the exhaust pipe is flush against the turbocharger (TC).
Note! Applies only to B52x4T: A new screw in the rear mounting for the heat deflector plate.
Secure the heated oxygen sensor (H02S) wiring at the mounting points. Connect the connectors.
-
the clamp at the divide downstream of the three-way catalytic converter (TWC).
Use a new clamp and a new screw .
Tighten to 25 Nm
-
The SIPS member.
Tighten to 25 Nm
-
the left front wheel. See: Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair/Removal and Replacement. Applies to
B52x4T.
Check
Test drive the engine. Check for any leakage.
Wipe the engine compartment clean.
Ensure that the steering wheel and gear selector lever are clean.
