volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Solenoids/Control System, Replacing|Page 22527 > < Solenoids/Control System, Replacing|Page 22525
Page 2
background image

Disconnect the screws for the oil cooler pipe from the transmission. Move the pipe to one side.
Seal the hole in the transmission with a plastic plug.
Position a container under the radiator drain cock. Drain the engine coolant.

Note! Avoid skin contact with the coolant. 

Close the nipple.

Disconnect the lower hose for the radiator to provide more space for removing the control system cover.

Remove: 

-

the screw for the front engine pad and the sub-frame

-

the screw for the ground lead bracket.

Note! Applies only to cars with parking heaters: 

Remove the 3 screws from the heater on the sub-frame.
Hang or tie up the heater on the left front fender.
Unhook the fuel line from its mountings in the sub-frame.
Lower the vehicle.

Install  999 5716 Reading off tool See: Tools and Equipment/999 5716 Reading Off Tool  directly above the engine lifting eye. Position the lifting beam

Solenoids/Control System, Replacing|Page 22527 > < Solenoids/Control System, Replacing|Page 22525