volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Removing|Page 23153 > < Removing|Page 23151
Page 27
background image

Test drive the vehicle with the test program selector in all three positions (E, W, S)

Checking the oil level 
Check the fluid level when the transmission and fluid are warm.
The gear selector should be in P and the engine should be idling.
At room temperature (+20° C) the oil level is close to the MIN-mark on the "cold range" on the dipstick.
The "Cold range" (+40° C) is reached after approx.15 minutes idling in the workshop and the "warm range" (+80° C) after about 30 minutes driving on
main roads at an air temperature above +15° C.
Also see  Checking oil level See: Service and Repair/Procedures/Checking the Oil Level.

Note! The check should be carried out at an oil temperature of +80° C. 

 Checking the diagnostic trouble codes (DTCs) after test driving  
Check that no diagnostic trouble codes (DTCs) have been registered. Erase any diagnostic trouble codes (DTCs)

Returning the transmission (Only when replacing the entire transmission assembly) 

Removing|Page 23153 > < Removing|Page 23151