C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
Install a new locking screw and lock nut on the cylinder. Tighten to 25 Nm .
Connect the push rod to the clutch pedal. Install the locking clip. Ensure that locking clip is seated in the groove on the shaft journal.
Install new lock nuts on the power brake booster. Tighten to 25 Nm .
Note! Applies to certain versions only: Install the position sensor on the clutch pedal.
Press the insulation into place against the firewall. If necessary secure the insulation using contact adhesive.
Installing the panel
