C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
Ensure that the rubber seal locates all the way around.
Note! Follow-up work: To install the transmission, see Transmission, installing See: Service and Repair/Removal and
Replacement/Transmission, Installing.
Primary shaft seal 44.6 mm
Special tools:
999 5726 Puller See: Tools and Equipment/999 5726 Puller
999 5727 Drift See: Tools and Equipment/999 5727 Drift
Removal
Note! Preparations: To remove the transmission, see Removing the transmission See: Service and Repair/Removal and
Replacement/Transmission, Removal.
Removing the clutch cylinder
Remove the rubber seal from the clutch cover. Move it inwards on the pipe towards the clutch cylinder.
Pull out the retaining clip locking the quick-release connector on the pipe to the junction.
Remove the adapter. Keep it in a plastic bag to prevent contamination. Install a protective plug in the end of the pipe.
Remove the clutch cylinder.
Clean the mating surfaces in the clutch cover. Check any leakage from the transmission.
Installing the extractor for the primary shaft seal
