volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Removing Transmission Cables|Page 23483 > < Removing Transmission Cables|Page 23481
Page 1
background image

Shift Cable: Service and Repair
Transmission Cables, Installation

Transmission cables, installation 

Special tools: 
 999 5511 PRESS TOOL  See: Tools and Equipment/999 5511 Press Tool 

Caution! Take care not to damage the cables or cable sheaths by bending at tight angles. Take care not to damage the cable boot. 

Note!  Check that the gear selector assembly rubber bushings and spacer sleeves are OK. 

Push the new transmission cables through the firewall  

Check that they are on the correct side of the steering column.

Note! The left mounting on the gear selector assembly, and the transmission cable that goes on the left both are marked  yellow. 

-

Push the transmission cables into the sheath as far as possible and work the cables one by one below the air duct and through bracket on the center
console.

-

Check that the cable marked yellow is operating smoothly in its sheath. The other cable runs slightly stiffer because there is more grease in the
sheath.

Install:  

Removing Transmission Cables|Page 23483 > < Removing Transmission Cables|Page 23481