S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Applies to cars with the Keyless system
-
Disconnect the cable (1) at both ends and remove it. It will no longer be used. The cable is internally connected to a gray connector below the right
tail lamp.
-
Take the cable harness with rubber grommet from the kit. The cable harness has a taped rubber grommet with integrated cable for the keyless
system.
-
Pull in the end with four connectors through the hole in the car and fit the rubber grommet.
-
Fit the connector (1) for the sensors in the designated location below the tail lamp. Make sure that the clip engages properly.
-
Fit the cable with the clips (2).
Applies to cars with the Keyless system
-
Plug the connector into the antenna (1).
Applies to others
-
Secure the connector using a cable tie so that it does not rattle.
