S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Applies to cars with a tow hitch
-
Detach the towbar wiring connector from the Trailer Module (TRM).
-
Detach all cables from the connector and pull the cables out through the rubber grommet. The number of cables may vary depending on the towbar
wiring used.
-
Remove the rubber grommet. It will not be used again.
-
Cut off the top of the large rubber nipple on the new grommet and route the cable harness for the tow hitch through.
Hint: Lubricate the cable harness with something that will not damage the rubber grommet and route the cable harness through the hole.
Applies to 13-pin towbar wiring
-
Refit the ends of the cables in the connector in as follows: