volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Universal Bus Module (USB)|Page 13742 > < Universal Bus Module (USB)|Page 13740
Page 29
background image

-

Take two large tie straps from the kit and secure the cable from the microphone on top of the collision pipe.

Applies to cars with external amplifier

-

Also secure the cable harness B, that is to be later routed back to the external amplifier.

Steps 78-98 apply to cars with external amplifier

-

Grasp the upper edge of the right-hand side cushion. Pull the side cushion forward so that the clip on the reverse releases.

-

Slide the side cushion up. Remove the side cushion.

-

Repeat the operation on the other side.

-

Pull off the rubber strip at the rear of the opening for the right-hand rear door.

-

Carefully pry off the lower panel on the C-post on the right-hand side. Carefully pry at the top edge. Use a plastic weatherstrip tool.

-

Pull the panel on the C-post so that the two upper clips release. Then continue down until the last two clips release. Remove the panel on the
C-post.

Universal Bus Module (USB)|Page 13742 > < Universal Bus Module (USB)|Page 13740