S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Spot-weld the replacement part. Tip diameter 8 mm.
For location of the spot-weld, see: Location of the spot-weld.
Also see Welding, general.
Weld the outer part of the cross member cowl panel.
Drill 8 mm diameter holes for plug welds.
Weld the side member extension into place.
Installing the outer section of the lower side member
Grind clean.
Apply welding primer.
Spot-weld the replacement part. Tip diameter 8 mm.
For location of the spot-weld, see below.
Also see Welding, general.