S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Make holes on the reverse of the side panel at the existing markings. Use a
ø6 mm (15/64") diameter drill bit
-
Clean around the edges of the holes.
Illustration B
-
Take the clips for the storage box from the kit and install them in the holes. Press the clips together as close as possible by hand
-
Take a hammer. Place a counterhold on the reverse of the side panel
-
Carefully tap the clips using the hammer, so that the clips engage.
-
Hook the side panel back into place using its clips
-
Reinstall the rubber strip at the left-hand side panel
-
Reinstall the sill trim panel in the boot opening
-
Reinstall the upper floor supports if applicable
-
Reinstall the cargo compartment carpet.
Installing the storage box:
-
Hook the storage box into place on the installed clips
-
Press the storage box down so that its base is against the lower edge of the side panel.