S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Brake Fluid Reservoir: Service and Repair
Reservoir, Brake Fluid, R.H.D
Reservoir, brake fluid
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Preparatory work
Removing the master cylinder
Remove the master cylinder. See: Master cylinder, brake, R.H.D See: Brake Master Cylinder/Service and Repair/Master Cylinder, Replacing/Master
Cylinder, Brake, R.H.D
Removal
Removing the brake fluid reservoir
Remove:
-
the 1 screw on the side of the brake fluid reservoir
-
the reservoir.
Note! Clean around filler cap at the connector between the reservoir and master cylinder. This is to ensure that no contaminants enter the
brake system.
Installation
Note! For tightening torques, see Specifications. See: Specifications/Tightening Torque
Installing the brake fluid reservoir
Note! Check the seals. Replace if necessary.
Note! Only use brake fluid to lubricate the seal rings in the brake system.