S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Remove the air baffle from underneath the bumper cover in order to allow access for inserting the cable between the left-hand side end face of the
front grille and the seal in front of the radiator.
-
Route the front engine block heater socket's cable through at the seal by the lower front grille's left-hand side end face. Route it above the radiator's
left-hand bracket (1) and up to the lower edge of the side member. Clamp it by the bracket (1) using a tie strap from the kit. Route it along the
lower edge of the front member and over the drive shaft. Route the cable up slightly in the engine compartment.
Illustration B
-
Press the cable into the previously installed clips.
-
Reinstall the air baffle in the bumper cover and to its rear mounting in the bracket, in the lower edge of the radiator.
-
Reconnect the connectors for the fog lamps if applicable.
-
Press the ends of the bumper cover into place on the body.
-
Position the cable as illustrated, and clamp it in at the top of the strut using a tie strap from the kit. Route it up to the top of the engine
compartment.