S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Clamp the cable from the front engine block heater socket in at the top of the strut using a tie strap from the kit.
-
Grease O-ring on the front engine block heater socket's connector using low temperature grease (P/N 1161417-9).
Note! Do not get any grease on the surfaces of the connector.
Installing the engine block heater
-
Remove the cover on the radiator expansion tank.
-
Unscrew the drain nipple in the radiator pipe above the oil cooler in front of the right drive shaft. Drain the coolant.
