S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Connect the short electrical cable (which was routed earlier) to the engine block heater. Press it firmly into the engine block heater connection.
-
Press in a locking sleeve from the kit over the cable splice.
-
Pull the radiation shield up so that it fully covers the connector on the heater.
-
Take the grey tie strap kit and clamp the radiation shield by the heater in the upper edge.
Illustration A applies to cars without turbocharger
On cars with petrol engine without turbo, route the cable with radiation shield below the power steering hoses/pipes.
-
Fit a double tie strap to the two steering gear pipes and the cable with radiation shield.
-
Fit the double tie strap over the hoses' press sleeves.
Illustration B applies to cars with turbocharger
