S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Take the remaining hose and two hose clamps from the kit. Connect the hose between the oil cooler and the lower outlet on the heater. The end
with the long straight section must be connected to the oil cooler.
-
Tighten the hose clips.
-
Take the radiation shield from the kit and thread on the joint cable of the heater.
-
Connect the short electrical cable (which was routed earlier) to the engine block heater. Press it firmly into the engine block heater connection.
-
Press in a locking sleeve from the kit over the cable splice.