S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Pull the radiation shield up so that it fully covers the connector on the heater.
-
Take the grey tie strap kit and clamp the radiation shield by the heater in the upper edge.
Illustration A applies to cars without turbocharger
On cars with petrol engine without turbo, route the cable with radiation shield below the power steering hoses/pipes.
-
Fit a double tie strap to the two steering gear pipes and the cable with radiation shield.
-
Fit the double tie strap over the hoses' press sleeves.
Illustration B applies to cars with turbocharger
On cars with petrol engine and turbo, route the cable with radiation shield under the power steering hoses/pipes and under the turbo pipe.
-
Fit a double tie strap to turbocharger pipe and the cable with radiation shield.
-
Fit a double tie strap to the cable and the left power steering pipe.
-
Reinstall the left-hand fender liner. Tighten the fender liner to the left-hand side member.
-
Tighten the two fender liners to the bumper shell on the right and left-hand sides.
-
Refit the covers to the nozzles for the headlamp high-pressure washers.
-
Fill with coolant, run the engine to operating temperature, bleed the cooling system and check that there are no leaks.
