S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Stabilizer Link: Service and Repair
Front
Anti-roll bar link front, replacing
Note: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information in the illustrations is always correct.
Removal
Removing the front anti-roll bar link
Remove:
-
the wheel
-
the anti-roll bar link from the 2 mountings.
Note: Use a Torx-wrench as a counterhold so that the boot is not damaged.
Installation
Note: For tightening torques, See: Specifications.
Installing the front anti-roll bar link
Install:
-
the anti-roll bar link
-
the 2 M10 nuts. Use new nuts.
Note: Use a Torx-wrench as a counterhold so that the boot is not damaged.
Finishing
Install the wheel.