S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Note! The end of the clamp equipped with cut-outs must be turned towards the lower edge of the gear selector lever knob. The two vertical
cut-outs (1) in the clamp must fit into the corresponding ridges (2) in the lower section of the knob.
-
Take the clamp and guide it onto the lower section of the gear selector lever knob, press it against the lower section of the knob and snap it closed.
-
Check that the gaiter is firmly attached and that the clamp has snapped shut properly.
-
Turn the inside of the gear selector lever gaiter back in.
-
Press the gear selector lever knob onto the gear selector lever and check that it is firmly attached.
-
Fit the gaiter in the centre console starting with the rear end.
Applies to automatic gearboxes
-
Turn the circlip on the underside of the gear selector lever knob. Turn the circlip a quarter turn anticlockwise to stop.
-
Pull the gear selector lever knob straight up.
-
Position the new gear selector lever knob in the same position as the old one was removed from.
-
Press the gear selector lever knob down. Turn the circlip a 1/4 of a turn clockwise to stop.
-
Check that the gear selector lever knob is secured correctly.
