S60 L5-2.4L VIN 64 B5244S6 (2003)
Only for cars without pre-routed Melbus cable
-
Remove the bracket with dashboard environment panel and the radio from the centre console: Pull the lower edge out and downwards until it
releases from the mounting at the upper edge. Then fold backwards.
Note! Do not damage the removed components or the surrounding panels.
-
Disconnect the connectors from the radio and dashboard environment panel. Also disconnect the connector from the phone keypad if applicable.
Place the unit to one side.
Applies to all models
-
Remove the two screws holding the front edge of the tunnel console in the centre console.
-
Remove the side panel on both sides (1) of the tunnel console. First twist the clip at the rear edge of the panel a 1/4 turn. Pull the rear edge of the
panel outwards and rearwards.
-
Only for cars without pre-routed Melbus cable: Remove the sill trim panel (2).
