S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Angle the dashboard environment panel outwards so that it is possible to insert a couple of fingers between the centre console and the short side of
the dashboard environment panel.
-
Pull the dashboard environment panel downward maintaining the same angle and remove the dashboard environment panel. The panel is well
secured, so some force is required to detach the panel.
-
Disconnect the connectors on the reverse of the dashboard environment panel. Place the dashboard environment panel to one side.
Note! If any of the outer hooks fail then this must be rectified. The method for this is described in the Workshop Manual in the section on
the dashboard.
-
Remove the screws (1) from the bracket for the radio.
-
Pull the bracket with the radio outwards at the lower edge, and push the whole unit downwards.
-
Unplug the connectors from the radio.
-
Remove the radio.
Applies to all models: Installing the amplifier
-
Remove the covers (1) for the screws to the right-hand seat.
-
Remove the screws (2) from the seat base.
-
Unplug the connectors under the seat.
