S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Tip the seat back.
-
Remove the panel (1) on the right-hand side of the centre console. Turn the clip at the rear edge of the panel through 90°. Pull the rear edge of the
panel outward and backward.
-
Remove the sill moulding (2) at the right-hand front door.
-
Detach the carpet (3), by the front left mounting for the right-hand seat. Pull the carpet forward and to the right.
-
Fasten up the carpet in the door stop with a cord.
-
Fold the rear carpet (4) backwards at an angle.
-
Connect the thick cable harness from the kit to the sockets in the amplifier.
-
If there is a pre-routed cable (2) to the power supply under the right-hand seat, connect it and then skip over steps 14 - 17. If not, connect the cable
from the kit for the power supply to the amplifier.
-
Install the amplifier with the two enclosed screws (1) and tighten.
-
Route the power supply positive cable together with the cable harness running to the radio cut-out.
Illustration A applies to the S60/V70/XC70
Route the cable harness:
-
under the cut-away tab (1) of the carpet at the left-hand front mounting for the right-hand seat.
