S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Remove the clips (1) and plastic nut from the left front side panel in the cargo compartment.
-
Remove the front side panel.
-
Take the DIN cable from the kit, lift up the floor carpet and route it underneath, up between the front air duct (1) and the strut (2) for the centre
console.
Note! Make sure that it is the connector with a guide pin which points upward (see illustration), which is routed to the radio socket.
-
Route the cable through the compartment for the radio.
-
Clamp the cable in the strut (3), using the clamp from the kit.
-
Route the cable on above and alongside the front air duct to the member (4) for the seat mounting.
-
Clamp the cable at the existing cable harness (5).
-
Route the cable (1) under the carpet, along the left-hand side of the car to the rear door.
-
Route the cable further under and along the front cable duct (2). Continue along the right-hand side of the rear cable duct (3).
