S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Route the DIN cable (1) along the two cable ducts/cable harness (2) under the insulation panel and out through the hole in the body to the cargo
compartment.
-
Route the DIN cable under the four connectors in the front cable duct.
Applies to cars up to and including model year -2004 (CH -424999)
-
Take the cable harness for power supply (1) from the kit. Connect the ground lead to the rear ground terminal (2) under the seat cushion. Tighten
to 10 Nm (7 lbf.ft.).
-
Route the ground lead under the four connectors in the front cable duct.
-
Route the power supply cables (1) along the rear cable duct (3) under the insulation panel and out through the hole in the body to the cargo
compartment. Position the cable end with the two red/white (R/W) single cables and the two green connectors at the rear fuse holder. Route the
long cable with the green connector (4) to the pre-routed DIN cable's connector.
Applies to cars from model year 2005- (CH 425000-)
-
Take the cable (1) for power supply from the kit. Connect the ground lead to the existing ground terminal behind the battery. Tighten the screw.
Tighten to 10 Nm (7 lbf.ft.). Position the cable end with the two red/white (R/W) single cables and the two green connectors (2) by the rear fuse
holder.
-
Route the cable harness on the left-hand side of the cable duct. Route the long cable with the green connector (3) to the pre-routed DIN cable's
connector.
