volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Adapter 7 to 4 Pole Wiring For Towing|Page 16727 > < Adapter 7 to 4 Pole Wiring For Towing|Page 16725
Page 23
background image

Illustration C applies to cars with three rows of seats

-

Fold up the seats in the third row (applies to cars with three rows of seats).

-

Remove the screws (2) for the load securing eyelets in the left-hand side panel.

-

Remove the covers (3) over the front mountings for the left-hand side panel. Pry the covers off. Use a plastic weatherstrip tool or a small
screwdriver.

-

Remove the screws (4).

-

Remove the clip (5) at the bottom of the storage compartment in the panel (Applies to cars with three rows of seats).

-

Remove the panel by pulling out the upper edge slightly so that the clips on the inside release. Pull the panel straight up.

-

Remove the drain hose (1) from the battery.

-

Remove the rubber seal (2). It will not be re-used.

-

Pull off the small, thin rubber strap on the new rubber seal.

-

Insert the old drain hose through the new rubber seal. Make sure the hose is not obstructed and that it is not folded.

Note! It is only possible to connect one of the functions (rear fog lamps, charging or reversing lamps). You can also choose not to connect any of
the functions.

If the rear fog lamp function will be used: Illustration A 

Adapter 7 to 4 Pole Wiring For Towing|Page 16727 > < Adapter 7 to 4 Pole Wiring For Towing|Page 16725