S60 L5-2.4L VIN 64 B5244S6 (2003)
Turn the clip 90 degrees and pull it out.
HINT:
Keep the clip. The clip can be used the next time the lock is removed, in order to establish the position of the link for the lock cylinder.
Angle in the lock mechanism.
Install:
-
the 3 M6 screws. Tighten
-
the link from the outside handle
-
the link from the lock cylinder.
CAUTION: Ensure that the lower link mounting (for the lock cylinder link) on the lock mechanism has been placed in the center position, so
that the holes (for the transit safety catch) in the casing for the lock mechanism and the hole in the link mounting arm correspond.
Install:
-
the link for the lock button
-
the connector
-
the end of the cable.
CAUTION: For vehicles with deadlocking, the cover must be installed. See Handle, outer, front side door, replacing.
Install guide rail. Always use a new blind rivet, P/N 982565.
Install:
-
the guide molding for the guide rail
-
the run-off profile.
-
the door panel.
