S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Unscrew the screw (1) almost all the way on the left and right-hand sides in the rear edge of the wheel arch.
-
Press the screw using a screwdriver until the loose end pieces on the inside of the bumper cover are pressed backwards.
-
Carefully drill out the rivets (2) underneath the bumper on both sides. Use a dia. 6 mm (1/4 inches) diameter drill bit. Take care not to damage any
of the plastic components.
NOTE: There may be another installation procedure with more blind rivets on older cars.
Illustration A
-
Pull the bumper backwards slightly. Bend out the sides (1) so that they detach from the mountings (2). Then pull the bumper backwards until it
detaches completely.
-
Place the bumper on a clean underlying surface that will not damage the paint.
Illustration B
Applies to cars with parking assistance
-
Detach the bumper in accordance with the above.
Carefully pull the cable (3) out through the hole in the car.
-
Place the bumper on a clean underlying surface that will not damage the paint.
