S60 L5-2.4L VIN 64 B5244S6 (2003)
Remove:
-
the rivet (1) on the bracket (2) for the silencer. Use cutting nippers.
-
the screws (3) on the bracket.
-
the bracket, by detaching the rubber mountings (4). The bracket will not be used again.
-
Remove the screws (1) and the bracket (2) from the right-hand side of the rear of the car. The bracket will not be used again.
-
Install masking tape on the outside of the bumper to avoid damage from the base of the saw. Install masking tape opposite the cutting points and
over the bumper cover.
CAUTION: Particular care must be take when cutting out in the bumper for the R-line. The brackets for the air intake's mesh could be
damaged.
-
Leave the masking tape in place throughout the installation procedure.
Applies to cars from model year 2005- (CH 425000-)
-
Cut along the markings on the inside of the bumper to make the cut-out for the towbar. Cut out so that the marking lines remain in the bumper
