S60 L5-2.4L VIN 64 B5244S6 (2003)
afterwards.
Applies to cars up to and including model year -2004 (CH -424999)
-
Use the cutting template from the kit to mark the cutting lines on the inside of the bumper. Position the cutting template as illustrated.
-
Carefully mark out the cutting lines around the cutting template.
-
Cut along the markings on the inside of the bumper to make the cut-out for the towbar. Cut out so that the marking lines remain in the bumper
afterwards.
Applies only to R-line
-
Apply masking tape on the outside of the exhaust pipe clip to avoid damage from the base of the saw.
Leave the masking tape in place during installation.
-
Cut along the marked raised area and remove the cut-out area.
Applies to all models
-
After cutting, smooth off the edges using a file.
Installing the towing member
Illustration A
-
Clean any underseal and dirt from the mating surfaces between the towbar end face and the bodywork.
-
Install the screws (2 and 4) from the underneath with the washers (3 and 5) between. Finger tighten.