S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Push the end of the Velcro strip over the hole to one side
-
Drill out the hole. Use a -7.5 mm (19/64") drill bit with a 25 mm (1") drill stop
-
Remove any swarf
-
Carry out the operation on all Velcro strips.
-
Fold the Velcro strip back over the drilled hole
-
Press a clip (from the kit) through the Velcro strip and the hole in the panel.
Note! Do not press the centre of the clip. Hold the edges.
-
Lock the clip by pressing the centre
-
Carry out the operation on all Velcro strips
-
Press the protective cover into place against the Velcro strips along the upholstery for the side panel.
Finishing work
-
Fold the rear backrests up. At the same time insert the protective cover in the gap between the backrests and the front edge of the cargo
compartment floor as illustrated.