S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Take the rail, the hooks and the end stop from the kit
-
Thread the hooks onto the rail. Insert the end stop
-
Take the two mounting plates and the screws from the kit
-
Mount the plates in the outer holes of the rails. Use the screws. The long section of the mounting plate must point outwards
-
Lift the rail. Insert the mounting plates in the two outer holes on the underside of the parcel shelf
-
Centre the mounting plates over the holes. Pull the rail backwards to the rear edge of the holes. Secure the rail using the two screws.
Applies to the S80 (-06)
-
Take the rail, the hooks and the end stop from the kit
-
Thread the hooks onto the rail. Insert the end stop
-
Take the two mounting plates and the screws from the kit
-
Mount the plates in the rail's penultimate holes. Use the screws. The long section of the mounting plate must point inwards.
-
Lift the rail. Slide the left-hand mounting plate into the left-hand hole on the underside of the parcel shelf. Then slide the right-hand mounting plate
into the hole second from the right
-
Slide the rail as far to the right as possible so that the mounting plates are over the panel surfaces between the holes. Pull the rail backwards to the
rear edge of the holes. Secure the rail using the two screws.
Applies to the S80 (07-)
