S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Turn the centre console locker upside down
-
Drill out the two pre drilled lugs (1). Use a 4 mm (5/32") diameter drill bit. Use a larger drill bit or a counter sink in the hole from inside the centre
console locker to guide the screws
-
Reinstall the centre console locker in the centre console.
-
Take the two spacers (1), L=9 mm (23/64"), from the kit. Position the spacers over the holes at the rear edge of the storage compartment
-
Take the two spacers (2), L=20 mm (51/64"), from the kit. Apply butyl tape under the spacers. Secure the spacers over the drilled holes at the front
edge of the centre console locker.
Illustration 27A
Hint: Apply soap to the rubber strip to make it easier to install the storage compartment in the centre console locker.
-
Press down the storage compartment in the centre console locker
-
Install the two long screws (1) from the kit in the front holes in the storage compartment and through the two spacers. Tighten a few turns. Use an
angled torx screwdriver
-
Insert the two remaining screws through the rear holes in the storage compartment and through the two spacers
-
Insert the threaded plate underneath the panel where the spring nuts were removed
-
Install the screws in the nuts on the threaded plate. Tighten the screws. Use an angled hex socket
