S60 L5-2.4L VIN 64 B5244S6 (2003)
Install:
-
two plus one screws on the Left hand seat
-
two plus two screws on the right hand side of the transmission
-
the spring. See Tension spring See: Service and Repair/Removal and Replacement/Front Seat/Second Generation Power Seats/Tension Spring
-
wiring
-
the connector
-
the bracket and cross member. See Bracket and cross member See: Service and Repair/Removal and Replacement/Front Seat/Second Generation
Power Seats/Bracket and Cross Member
-
the seat frame. See The seat frame See: Service and Repair/Removal and Replacement/Front Seat/Second Generation Power Seats/The Seat Frame
-
the seat. See Removing power seats, tilting See: Service and Repair/Removal and Replacement.
Note! Removed seat rails must always be checked for movement. Use Vernier calipers to measure from the fixed to the moving component. Both
rails should have the same measurement. If not, adjust one of the rails. If the rails do not have the same measurements the seat does run
parallel. This leads to increased wear and noise.
The Support For the Motor For Front-Rear Adjustment
The support for the motor for front-rear adjustment
Removing the support for the motor for front-rear adjustment
