S60 L5-2.4L VIN 64 B5244S6 (2003)
Note! The thickest of the bearing halves shall always be installed in the intermediate section. This is to keep the center line as straight as
possible.
Intermediate part
Wipe the surfaces dry.
Apply liquid gasket 11 61 059 on the intermediate section. The surface must be completely covered without any excess. Use roller 951 2767 Roller See:
Tools and Equipment/951 2767 Roller
Thoroughly lube all bearing shells and the thrust bearing surface with oil.
Tightening the intermediate section
Install the two old screws for the flywheel and carrier plate at the rear edge of the crankshaft.
Lift these and the front of the crankshaft.
Carefully lay the crankshaft into place in the block.
The crankshaft must not be turned before the intermediate section has been torque tightened. Position the intermediate section.
Lubricate and install all the screws.
Install the intermediate section and the screws on the exhaust side at bearing recesses 2 and 5.
Pull the intermediate section down against the cylinder block.
Caution! The M8 bolts on the exhaust side have two lengths.
Note! Use new M10 bolts.
1. All M10 screws.20 Nm
2. All M10 bolts. 45 Nm
3. All M8 bolts. 24 Nm
4. All M7 bolts. 17 Nm
5. Angle-tighten all M10 screws.90°
Tighten the screws in sequence from the middle and out.
Marking the connecting rod (where applicable)
