S60 L5-2.4L VIN 64 B5244S6 (2003)
Apply liquid gasket 11 61 059 on the oil sump. Use roller 951 2767 Roller See: Tools and Equipment/951 2767 Roller.
The surface must be completely covered without any excess.
Position the pan and install all screws
Caution! Check that the rear edge of the oil pan is in line with the rear edge of the cylinder block. Permissible tolerance ± 0.025 mm. Use a steel
ruler and feeler gauge.
Tighten the screws from the rear of the pan and forward.
Installing the oil cooler and oil filter
Install
-
new sealing rings in the sump
-
the oil cooler. Tighten
-
the oil filter.
Installing the rear crankshaft seal
Use standard handle 999 1801 STANDARD SHAFT See: Tools and Equipment/999 1801 Standard Shaft and drift 999 5676 Drift replaced by 9997174
See: Tools and Equipment/999 5676 Drift Replaced By 9997174.
Lubricate the drift face. Thread the seal onto the drift.
Tap in the seal until the drift bottoms against the block.