S60 L5-2.4L VIN 64 B5244S6 (2003)
Always use new screws. Ensure that the thread sealant on the new screws is intact. If not apply a few drops of sealant 1161056 to the thread.
-
Align gear sector: 999 5112
-
Pull the flywheel/carrier plate towards the crankshaft using the 3 nuts on special tool 999 5678. The turned section of the nut must be turned
towards the flywheel/carrier plate.
-
Install the other screws. Tighten.
-
Replace the 3 special screws with new standard screws. Tighten.
-
Then angle-tighten all 10 screws crosswise. Use 951 2050. Tighten.
-
Ensure that the flywheel sensor and bracket are installed. Install the clutch driven plate and clutch.
Installing the transmission
Install the transmission.
Checking the engine:
Test drive the car to check the function of the engine and the transmission.
