S60 L5-2.4L VIN 64 B5244S6 (2003)
Remove:
-
the screw holding the dip stick pipe to the intake manifold
-
the clip for the servo pressure pipe
-
the screw at the support bracket (under the intake manifold). Disconnect the connector for the electronic throttle module (ETM)
-
unscrew the four upper screws completely. Slacken off the lower screws a few turns
-
the intake manifold. Lift the intake manifold approximately 20 mm. Allow the crankcase ventilation hose to run through the intake manifold
without disconnecting it from the flame trap
-
the hose on the Positive temperature coefficient (PTC) nipple for crankcase ventilation. Lift out the intake manifold
-
the upper coolant hose.
Removing components
-
Separate the connectors for the ABS sensor and level sensor in the expansion tank
-
Lift up the expansion tank and the brake fluid reservoir. Place them on top of engine.
Warning! Make sure that no power steering fluid leaks out. It is very flammable.
-
Remove the auxiliaries belt.
Setting up the engine