S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Remove the two clips from the kit. Check that the tab (1) is angled a few millimetres below the other surface. If it is not, bend the tab down as
illustrated.
-
Press the two clips into the gap between the lower edge of the headlamp and the weatherstrip, approximately at the point illustrated. Use the
headlamp guard as a template.
-
Insert a plastic weatherstrip tool between the weatherstrip and the clips. Bend the tab down further on the clips to ensure that the clips are secure.
Note! Do not damage the paint work.
