S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Remove the protective film from the headlamp guard (from the kit).
Applies to cars without headlamp washers
-
Position the headlamp guard opposite the headlamp.
Applies to cars with headlamp washers
-
Fold the headlamp washer out
-
Position the headlamp guard so that the cut out in the lower edge is opposite the two stops (4) for the headlamp washer.
Applies to all cars
-
Hook the headlamp guard into place in the holes (1) in the lower edge of the two clips (2). These clips slide sideways to suit the holes in the
headlamp guard
-
Fold up the headlamp guard towards the mounting strip (3).
Note! Ensure that the stop does not catch the headlamp guard when folding it upwards on cars with headlamp washers. Lift the guard slightly
so that the stop is positioned in the cut out.
Hook the headlamp guard into place. Secure the hook on the previously installed mounting strip in the hole in the top edge of the headlamp guard as
follows:
-
Slide the mounting strip forward as far as possible. Ensure that the mounting strip is not concealed under the weatherstrip. Press the front edge of
the mounting strip downwards. Slide the hole for the headlamp guards over the hook. Secure the hook in the hole.
