S60 L5-2.4L VIN 64 B5244S6 (2003)
NOTE: Do not heat the edge or groove on the housing; it may deform.
Wear protective gloves.
Begin by heating around the top of the lens towards the bonding in the housing. Use a high heat setting so that the lens become very hot (the hotter it is,
the easier it is for the knife to penetrate the adhesive).
Insert the knife between the lens and the plastic edge. Carefully run the knife through the adhesive all the way around the housing a couple of times while
heating the top of the lens. Do not damage the plastic edge with the knife.
NOTE: The adhesive leaves strings which will stick to the base and are difficult to remove.
Pry the glass straight up approximately 5 cm. Start at the side of the outer end. Do not damage the plastic edge on the housing.
Lift and hold up the lens.
