S60 L5-2.4L VIN 64 B5244S6 (2003)
Note: For tightening torques not in the text, See Specifications.
Install (common)
-
the plugs for the test holes. Tighten to 20 Nm
-
the ignition coils according to the earlier markings
-
the ground connections
-
the connector for the variable valve timing solenoid. Remove tool 999 5754.
Install (naturally aspirated engine)
-
the trigger wheel. Tighten to 17 Nm.
Note: Ensure that the trigger wheel is correctly positioned against the camshaft.
-
the Camshaft Position (CMP) sensor housing
-
the cover over the ignition coils
-
the upper timing cover
-
the crankcase ventilation hose on the inlet hose
-
the inlet hose between the Air Cleaner (ACL) and Throttle Body (TB)
-
the plastic nuts from the cover in the fender liner
-
the right front wheel.
Install (turbocharged engine)
-
a new cover over the intake camshaft
-
secure the cable harness for the injector
-
charge air pipe above the engine and holder at the rear of the engine.
Install (common)
-
the plastic nuts from the cover in the fender liner
-
the right front wheel.
