S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Install the branch connector on the bracket with a screw and nut from the kit. Make sure that the screw does not catch the pipe to the steering
assembly on the rear. If this is the case, swap the places for the screw and nut.
Do not tighten the bracket yet, the cables and locking sleeves must be installed first.
-
Grease in the rubber grommet with low temperature grease, part no. 1161417-9 in order to ease the cable through and to locate it in the hole in the
body more easily.
-
Thread the cable for the passenger compartment connector socket through the rubber grommet.
-
Guide the cable for the passenger compartment connector socket through the hole in the body.
HINT: Pull the rubber grommet into place from inside the passenger compartment using the cable if it is difficult to position it from the engine
compartment side.
-
Pull out a part of the cable for the passenger compartment connector socket from the passenger compartment. Any excess cable should be
concealed behind the carpet in the passenger compartment.
-
Take the heat deflector hose and two tie straps from the kit and thread it onto the cable for the passenger compartment connector socket. Pull the
heat deflector hose right up to the rubber grommet. Secure the heat deflector hose with both tie straps. If the heat deflector hose is too long, cut it
down to a suitable length.
-
Install the cable for the passenger compartment connector socket to socket (1) on the branch connector from the kit.
-
Connect the cable from the engine block heater to the socket (2) on the junction connector.
-
Connect the cable from the front engine block heater socket to the socket (3) on the junction connector.
