S60 L5-2.4L VIN 64 B5244S6 (2003)
If the fuel tank is replaced, see next step.
Install the wire on the new ejector for the level sensor and pump
Insert the hoses and wiring into the tank via the right-hand tank hole
Grip the right-hand level sensor and pump holder and pinch it so that the float is held in its lowest position
Carefully and slowly lower the holder. Carefully work the holder into place
Pull the wire so that the hoses and wiring end up on the left side of the tank
Install the left-hand level sensor on the ejector
Install the switches on the underneath of the left-hand level sensor
Remove the wire from the ejector.
Cable routing when replacing the fuel tank
If replacing the fuel tank, wire cannot be used.
The image shows how to route the fuel lines and electrical wiring in the tank. Use a plastic pipe at least 1.7 m long.
Hint: Use spare part plastic pipe between the carbon filter and EVAP valve.
Insert the hose through the hole for the level sensor on the left-hand side of the vehicle and press it through the tank and take the end of the hose through
the hole for the fuel pump.