S60 L5-2.4L VIN 64 B5244S6 (2003)
Install the two screws for the spring seat mounting. Tighten to 50 Nm.
Warning! Always check that the car does not lift from the lifting arms of the car lift when working with the lifting table.
Note! Do not tighten the screw for the bushing mountings. This is carried out later when the rear suspension is in the normal position.
Note! Guide in the propeller shaft when lifting operation.
Note! Ensure that the brake pipes or cable harnesses are not trapped.
Installing the rear axle (continued)
-
Slide up the centering sleeves 999 7017 Socket set rear axle See: Tools and Equipment/999 7017 Socket Set Rear Axle in the two rear mountings
on the sub-frame
-
Install the screw. Tighten lightly
-
Install the screws for the front mountings on the sub-frame. Install the screws through the brackets
-
Tighten all the front mountings. Tighten to 80 Nm
-
Remove the screws for the rear mountings on the sub-frame. Remove the centering sleeves
-
Install the screws for the rear mountings on the sub-frame. Tighten to 80 Nm.
Install:
-
the brake pipes in the plastic clips on the brackets
-
the screw for the fuel filter bracket (24Nm)
-
the screw for the brake line mounting stays (24 Nm).
Remove the lifting table.
Install:
-
the brake pipes in the plastic clips on the brackets
-
the screw for the fuel filter bracket. Tighten to 24 Nm
-
the screw for the mounting stay for the brake lines. Tighten to 24 Nm.
Remove the lifting table.
Install:
-
rivets to the heat shield on the sub-frame left rear bushing
-
the plastic nut for the fender liner.
