S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Install the propeller shaft in the viscous coupling / Active on Demand Coupling.
-
Secure the control arms down. Use retaining straps
-
Remove the screws for the shock absorber mounting
-
Pull the shock absorber from its mounting
-
Release the retaining strap
-
Press the suspension up to its normal position, see Normal position See: Service and Repair/Procedures.
Tighten:
-
the front mounting for the lateral link. Tighten to 80 Nm.
Install:
-
the retaining strap and pull down the control arms so that the shock absorber can be installed
-
the shock absorber
-
the screw. Tighten to 80 Nm.
Remove the retaining strap.
Installing the lateral link (not all-wheel drive (AWD))
-
Install tensioner and tension the rear suspension to the normal position. See Tensioner, instructions for use, M66, TF-80SC, AW55-50/51SN, M56
See: Service and Repair/Removal and Replacement/Tensioner, Instructions For Use
-
Tighten the front mounting for the lateral link. Tighten to 80 Nm.
Finishing
-
Install the wheel. See Installing wheels See: Wheels and Tires/Wheels/Service and Repair
-
Carry out wheel alignment.
Check/adjust the wheel alignment. See: Wheel alignment, checking / adjusting See: Alignment/Service and Repair.