S60 L5-2.4L VIN 64 B5244S6 (2003)
Install
-
the wheel spindle to the upper control arm. Do not tighten so hard that the toothed segment goes into the bushing on the wheel unit
-
the lateral links on the sub-frame. Finger tighten
-
tie rods on the sub-frame. Finger tighten
-
the lower control arm on the sub-frame. Finger tighten.
Press the control arm to the normal position using a mobile jack. See Normal position See: Service and Repair/Procedures.
-
Install a M12x70 mm screw and nut in the hole for the anti-roll bar on the control arm, to assist when measuring
-
Check the height measurement on the control arm. If necessary adjust the height measurement using a tie strap
-
Tighten the wheel spindle to the upper control arm. Tighten to 50 Nm
-
Install anti-roll bar control arms to the upper control arm. Tighten to 80 Nm.
Note! Counterhold the ball joint so as not to damage the boot.
Reinstall the sub-frame