S60 L5-2.4L VIN 64 B5244S6 (2003)
Hint: Make up two centering sleeves which are then placed on the rear mountings for the sub-frame. This will make it easier to center the rear
suspension. Measured at the centering sleeves A=20mm, B=13mm, C=50mm.
Place the sub-frame on a lifting table.
-
Lift up the sub-frame enough to be able to install the EVAP canister. Tighten to 25 Nm
-
Lift the sub-frame up completely to the bodywork.
Release the lower control arms from the sub-frame.
Note! Ensure that the brake pipes are not crimped at the sub-frame mountings.
