S60 L5-2.4L VIN 64 B5244S6 (2003)
Remove:
-
the screws from the bracket for the gear selector cable
-
the cable from the lever. Move the cable to one side.
Removing the gear-shift position sensor from the gear shift linkage rod
Remove:
-
the lever
-
the nut, lock washer and rubber seal from the gear-shift position sensor
-
the nut for the cable duct. Lift the cable duct to one side
-
the two screws for the gear-shift position sensor.
Carefully lift the sensor off the gear shift linkage rod.
Replacing the sealing ring for the gear shift linkage rod
Remove the old sealing ring. Use a small rounded off screwdriver.
Take care not to damage the rod.
Smear a little automatic transmission fluid on the new sealing ring. Install the ring. Use drift 999 5476 PUNCH See: Tools and Equipment/999 5476
Punch.
Installing the gear-shift position sensor